How to clean tinted windows without hazing or lifting the film. What ammonia does to tint, why film sits on the room side, and the coating you cannot clean.
The short answer on how to clean tinted windows is warm water, a drop of dish soap, and a soft cloth. Nothing else. No ammonia, no razor blade, no scrubby pad. Window film sits on the room side of the glass, it is softer than the glass, and the two things that ruin it are the bottle under your sink and the scraper in your toolbox. Here is how to tell which of your panes are filmed and how to clean them without hazing or lifting anything.
First work out which panes actually have film
Most people are not sure. Tint usually gets added years after a house is built, to a room that cooked in the afternoon sun, and then it gets forgotten about. Three ways to check, all from inside:
- Look at the border. Film is cut a hair smaller than the pane, so there is usually a thin strip of bare glass all the way around the edge. Untreated glass runs right up under the frame with no border at all.
- Feel the surface. A fingertip on film reads as plastic, slightly warmer and softer than the glass next to it, and a fingernail at the edge can usually find a lip.
- Look for the tells of old film. Small trapped bubbles, a purple cast the window next to it does not have, or a corner that has started to lift.
What ammonia does to tint
Ammonia is in most of the blue glass cleaners sold at the grocery store. On plain glass it is fine. On film it goes after the dyes and the adhesive underneath, and the damage is not dramatic enough to notice the day you do it. It shows up as a haze that will not wipe out, a purple cast across the pane, or film letting go at one edge. A few years of cleaning a filmed window with the wrong bottle and it looks tired in a way no amount of cleaning takes back out.
Strong vinegar belongs in the same category. If a label does not say it is safe for tinted glass, keep it off tinted glass.
The method, start to finish
Warm water and one or two drops of dish soap, in a spray bottle or a bucket. Two soft cloths, one damp and one dry. Wipe the pane with the damp one, then dry it in one direction with the other. That is the whole job, and it is why there is no real argument for hiring anybody to clean tinted interior glass.
Two habits matter more than the cleaner. Go gently right at the edges, because that is where film lifts first and a cloth corner caught under a lifted edge will peel it further. And keep anything with a hard edge away from the surface. A razor blade will take film off a pane in one pass, which people tend to discover halfway through the pass.
If the film was installed in the last couple of weeks, leave it alone. Small water pockets and a slight milkiness are normal while it cures and they clear up on their own.
The outside is just glass. Film goes on the interior, so exterior cleaning cannot hurt it, and the usual cold weather limits are what decide whether the outsides get done now or in spring.
The coating you cannot clean, and the haze you cannot reach
Modern double pane windows almost all carry a low emissivity coating, and people worry about scrubbing it off. You cannot. It usually sits on one of the two surfaces facing the sealed space between the panes, so there is no way to reach it from either side of the window with a cloth.
That also settles a common question. If a pane looks cloudy and nothing you do from inside or outside changes it, the cloudiness is between the panes. That is a failed seal rather than dirt, and no cleaner gets in there. More on spotting that in the piece on condensation and fogged panes. A greasy haze you can actually feel with a finger is a different thing again, usually cooking and heating residue, and that one does come off.
Clean the inside before the plastic goes up
This is the part worth acting on this week. The shrink film kits start going up around the Twin Cities in the first properly cold stretch of November. Once that plastic is taped across the sash and shrunk tight, the interior glass behind it is sealed off until spring. Whatever is on it in November is what you look through in March.
So clean the inside first, let it dry all the way, then tape. Same order if you are putting storm panels back on. It costs nothing to do it in that order.
One honest limit. If the film itself has gone purple and bubbled, cleaning will not improve it. That needs stripping and replacing by a film company, which is not cleaning and not work we do. We clean the glass, including filmed glass, around St. Paul and the rest of the metro.
If you want the exteriors handled before the weather closes the season, or the interiors done before the plastic goes up, there is a price at our quote page and times at our booking page.
Want a Gleam Team pro to handle it?
We serve St. Paul, Minneapolis, and the Twin Cities suburbs. Quotes and consultations are free.
Or call (763) 237-4106